![]() -j, which allows you to specify a loose source route as a list of up to nine IP addresses or hostnames in square brackets.įor a full list of all the arguments that can be used simply type TRACERT /? at the prompt.Running a ping test gives you a lot of information on the quality of your network connection.-d, which bypasses the DNS resolution process and instead sends queries directly to an IP address.Type TRACERT /? at the prompt for a complete list of all available arguments. ![]() “-h”, which specifies the maximum number of hops that can be used to reach the target device.Many additional capabilities may be added to the command by appending arguments to the basic syntax, such as: To find the route from your computer to the IP address “66.249.95.104”, open a Command Prompt and type: tracert 66.249.95.104.To find the route from your computer to the hostname “”, open a Command Prompt and type: tracert.The following are two examples of how to use the Tracert net utility: ” -w.” This allows you to set a timeout period in milliseconds for each ping request.įor a full list of all the arguments that can be used, simply type PING /? at the prompt.Ī TRACERT (traceroute) command should be run on any computer attempting to connect out of network using an IP address other than their own. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |